Voted No. 1 in Bathroom
TAP FOR LARGER IMAGE IN NEW TAB
Official Stockist
Grohe Avensys Dual Built-in - 34083 IP0 (34083IP0) Shower Spares
- Grohe 34083IP0
- 21 spares listed
- Brand: Grohe
- SKU / MPN: Grohe 34083IP0
- Categories: Grohe Shower Spares, Grohe Avensys Shower Spares
All available shower spares/replacement parts to fit the Grohe Avensys Dual Built-in - 34083 IP0 (34083IP0).
Use the main diagram to identify the shower spare(s) you need to replace. Then use the table below to locate your relevant part(s).
Not what you're looking for? Try our unique Shower Spares Finder.
Need any help identifying the fault with your shower? Take a look at our handy Fault Finder page.
Otherwise please feel free to contact us.
-
There are 13 currently available spares for the Grohe Avensys Dual Built-in - 34083 IP0 (34083IP0).
These are sorted by diagram reference first (if available) and then by product code in numerical / alphabetical order:
£136.35 Add to Basket -
Do you have a question about the Grohe Avensys Dual Built-in - 34083 IP0 (34083IP0)?
Click the button below to send a question to one of our expert members of staff and we will email you back a direct response. If we feel the information might be useful to other customers, we will also show your question below for others to see.
-
Hi There
I cannot get any hot water through my Grohe avensys 34083 shower valve. Sometimes by turning the hot control backwards and forwards the shower goes lukewarm but never hot. I have disassembled the control unit and cleaned the parts but still no hot water.
I have a second shower with a Grohe 34083 shower and have no problems with so the pressure and hot water from the storage tank is adequate.Hello, the Shuttle 07587 and Thermostat 00798 will need to be replaced, when replacing, grease the seal (with silicone grease) that is in the main body (shuttle seal).
-
called to avensys shower very poor hot water flow,temp at shower inlet around 57c, cold at inlet 7c,hot from combi.there is a none return valve on cold but no flow limiters ,not tested mains pressure but is quite good around 4bar this area,do you think limiter should be fitted.dose the limiter set come with full instructions .
thanks
garyHi, as you start off by saying it has poor flow, we suspect that either a filter or non return valve is blocked or jammed, check these first as this may be all it is.
Regards
-
