Mira 88 Exposed Shower Spares

Do you have a question about the Mira 88 Exposed?

Click the button below to send a question to one of our expert members of staff and we will email you back a direct response. If we feel the information might be useful to other customers, we will also show your question below for others to see.

Ask a Question

• I require a replacement knob for my Mira 88 exposed shower however all the pictures I have seen show a multi spline type fixing for the knob.
  Mine has only 4 x splines on the shaft, will the new replacement knob still fit?
  Thankyou

  hello, the part you need is 937.84, they may look slightly different to the original, but they will fit.

• The plastic fitting that holds the shower head and attaches to the vertical rod (allowing one to slide the head up and down, as required) has broken (after many years of good Mira 88 service!). I wonder if a replacement item is available? Apologies that I am unable to use the correct terms.
  With thanks in anticipation.
  Gerry

  Hi
  Mira have supplied various clamp brackets over the years, the link below show the ones we stock, hopefully one will look similar to yours, alternatively please send a picture of the one you require to salesdesk@showerspares.com where we will assist
  http://www.showerspares.com/mira_shower_accessories/mira_clamp_brackets/

• I have the service kit to maintain my Mira 88 Exposed but am unable to remove the large control knob after removing the temperature control knob and circlip. I live in a hard water area and am not sure when the Mira was last serviced.

  Hello, the knob just pulls off, they can get very difficult to remove, you may need to cut if off, then buy a new knob set 937.84.

• What is the replacement for a mira 88 exposed with the same pipe centres

  Hello, if you are ataying with a Manual shower then the 88 Gem is a straight replacement,
  http://www.showerspares.com/search/mira_gem_88_ev_1.1557.001/
  the link above will take you straight to it

• Just received the Mira 88 ( exposed ) service pack in the post. All parts OK, water off, loosened the big but and rari g to go. But not sure where to apply the grease, Can you help?
  Frank

  Hello, the grease can be applied to the large thread and on any o rings to prevent them binding when re-assembling.

• Can I replace a twist on tap with the up to date lever control into existing body of a mira 88

  Hello, we are very sorry, but they do not interchange